Frame Formats - Version II

The Ethernet Version II Frame Format

The following is a description of the frame format described by the original Ethernet Version II specification, as released by DEC, Intel, and Xerox.

Like the 802.3 spec, the Version II spec defines a Data Link Header consisting of 14 bytes of information, but the Version II spec does not specify an LLC header.

  
[This is a clickable diagram]

The Data Link Header

Offset 0-5: The Destination Address
The first six bytes of an Ethernet frame make up the Destination Address. The Destination Address specifies to which adapter the data frame is being sent. A Destination Address of all ones specifies a Broadcast Message that is read in by all receiving Ethernet adapters.

The first three bytes of the Destination Address are assigned by the IEEE to the vendor of the adapter, and are specific to the vendor.

The Destination Address format is identical in all implementations of Ethernet.

Offset 6-11: The Source Address
The next six bytes of an Ethernet frame make up the Source Address. The Source Address specifies from which adapter the message originated. Like the Destination Address, the first three bytes specify the vendor of the card.

The Source Address format is identical in all implementations of Ethernet.

Offset 12-13: The Ethertype
Following the Source Address is a 2 byte field called the Ethertype. The Ethertype is analogous to the SAPs in the 802.3 frame in that it specifies the memory buffer in which to place this frame.

An interesting question arises when one considers the 802.3 and Version II frame formats: Both formats specify a 2 byte field following the source address (an Ethertype in Version II, and a Length field in 802.3) -- How does a driver know which format it is seeing, if it is configured to support both?

The answer is actually quite simple. All Ethertypes have a value greater than 05DC hex, or 1500 decimal. Since the maximum frame size in Ethernet is 1518 bytes, there is no point of overlap between Ethertypes and lengths. If the field that follows the Source Address is greater than O5DC hex, the frame is a Version II, otherwise, it is something else (either 802.3, 802.3 SNAP, or Novell Proprietary).

User Data and FCS

Data: 46-1500 Bytes
Following the Ethertype are 46 to 1,500 bytes of data, generally consisting of upper layer headers such as TCP/IP or IPX and then the actual user data.

FCS: Last 4 Bytes
The last 4 bytes that the adapter reads in are the Frame Check Sequence or CRC. When the voltage on the wire returns to zero, the adapter checks the last 4 bytes it received against a checksum that it generates via a complex polynomial. If the calculated checksum does not match the checksum on the frame, the frame is discarded and never reaches the memory buffers in the station.